FreeWave Technologies
Knowledge base
-
Products
Solar
900 MHz
2.4 GHz Classic
Fusion
WaveContact
- WaveContact Series Accessories
- WC40i Modbus Wireless IO System
- WC30i-AXIS Wireless Angle Sensor
- WC30i-TZ Wireless Totalizer
- WC30i Wireless Pressure Sensor
- WC25i Wireless IO Module
End of Life Notices (EOL)
I/O wireless solutions
Licensed Radios
Satellite
empty -
Tool Suite
-
Manuals
-
FAQ's - Frequently Asked Questions
-
'How Do I' Guidance
-
FreeWave Data Portal
-
Product Advisories
-
Troubleshooting
-
FreeWave Training
-
Qualified Support Partners
-
Path Studies
-
ModuSense - Modular Sensing Gateway
Issues / Errors
How-To's
- ModuSense Introduction (EOL)
- Configuring your ModuSense gateway
- Validating your ModuSense Sensors
- Viewing and Submitting Diagnostic Info for your ModuSense Module
- Ensuring correct antenna placement and tightness
- California Proposition 65
Supported Sensors
- S.HS.BT.V5 - FreeWave HiveScale
- SD.ENV.01 - HiveBeats Environmental Monitor
- SD.FS1 - Wind Speed Anemometer
- SD.PM2512 - Air Quality, Temperature and Humidity Sensor
- SD.CF1 - Ultrasonic Wind Speed and Direction Sensor
- SD.WSQ - Temperature, Humidity and Barometric Pressure Sensor
Solutions
Promoted articles
- LED pattern for Serial radios in Multipoint Operation Mode
- FGR3-CE/C Serial Radios
- Setting up "Modbus TCP" or "Modbus RTU over TCP" in ZumLink
- Tool Suite - FreeWave's Radio Management software
- How do I Run Tool Suites Network Diagnostics in an Ethernet Network
- How Do I determine what diagnostic cable I need for Serial FGR Network
- How do I Run Tool Suites Network Diagnostics on a Serial Radio Network
- How do I add a new FGR Serial radio to my network
- Troubleshooting Flowchart - Classic Serial (FGR2-C, FGR3-C, etc.)